Nema 17 bracket

Hermawan

27 Nov, 2019 01:36 AM

Step By Step Basic Solidworks

1. Step 1: Open The Solidworks Software

   

   
   

   
   

2. Step 2: Click File >> New >> Part

   

   
   

   
   

3. Step 3: Draw L sketch

   Click sketch and draw using rectangle or line icon if you want trims or extends a sketch entity to be coincident or another,or deletes sketch entity click trim entities

   
   

   

   
   

   
   

4. Step 4: Extrude L model

   After the sketch finish,click feature >> Click extruded boss/base

   

   
   

   
   

5. Step 5: Sketch again

   Congratulation the L part already to sketch again hahahaha 😁 ,click front plane then make sketch base the dimension (use centerline when you in trouble to decide center point)

   
   

   

   
   

   
   

6. Step 6: Sketch circle

   When you already have center point ,Click sketch >> Circle >> Make from centerpoint until dimension same with picture below >> Exit sketch

   
   

   

   
   

   
   

7. Step 7: Extrude cut the circle

   Click features >> Extruded cut >> In direction menu click through all >> Click checklist

   

   
   

   
   

8. Step 8: Make straight slot sketch

   Click front plane then make sketch base the dimension (use centerline when you in trouble to decide center point) , when you already have center point ,Click sketch >> Straight slot >> Make from centerpoint until dimension same with picture below >> Exit sketch

   
   

   

   
   

   
   

9. Step 9: Extrude cut the slot

   Click features >> Extruded cut >> In direction menu click through all >> Click checklist

   
   

   

   
   

   
   

10. Step 10: Make circle and slot sketch

    Congratulation the hole almost already ,click sketch to sketch again hahahaha 😁 ,click top plane then make sketch base the dimension (use centerline when you in trouble to decide center point),  when you already have center point ,Click sketch >> Straight slot >> Make from centerpoint until dimension same with picture below >> Exit sketch

    
    

    

    
    

    
    

11. Step 11: Extrude cut the circle and slot

    Click features >> Extruded cut >> In direction menu click through all >> Click checklist

    
    

    

    
    

    
    

12. Step 12: Create fillet

    Congratulation the bracket almost done, click features menu >> Click fillet to creates rounded >> Click on the edge s >> Click checklist

    
    

    

    
    

    
    

13. Step 13: Finish

    Yeay the part have done 😎