Tutorial how to make engine part 11

Cylinders - 2

  1. Step 1:

    open a sketch on front plane and draw water canal profile

  2. Step 2:

    extrude it

  3. Step 3:

    create a plane bottom of body and use mirror command for to mirror water canal

  4. Step 4:

    after open a sketch on this surface

  5. Step 5:

    draw a sketch like this and use cut extrude command

  6. Step 6:

    go to left side, open a sketch and draw a sketch like this

  7. Step 7:

    extrude it. please attention that to make direction 'up to surface'. select the outer surface of the cylinder

  8. Step 8:

    open a sketch on same surface and draw semi-circular profile. it have to be closed profile

  9. Step 9:

    create the plane 3 ( it is at the center of water canal) then draw the path.( we will use sweep command)

  10. Step 10:

    use sweep command. then mirror it

  11. Step 11:

    create a inlet part like this

  12. Step 12:

    close the back side with your method

  13. Step 13:

    mirror all things and your water cooled 12 cylinders are ready