Tutorials

Complete MTB design in NX

22 3 Beginner
complete mountain bike design

NX 11:Creating Assembly

13 2 Beginner
A tutorial on Sub assembly and showing arrangements of hydraulic cylinder-piston assembly.

Car design in NX

9 1 Beginner
Car design in nx

Siemens NX Mechatronics Concept Designer

9 0 Beginner
nx mechatronics concept designer simulation

Roller bracket in NX

8 2 Beginner
Modeling and assembly

Drone Design in NX

7 2 Beginner
An unmanned aerial vehicle (UAV) (or uncrewed aerial vehicle,[2] [3]commonly known as a drone) is an aircraft without a human pilot on board and a type of unmanned vehicle. UAVs are a component of an unmanned aircraft system (UAS); which include a UAV, a ground-based controller, and a system of communications between the two. The flight of UAVs may operate with various degrees of autonomy: either under remote control by a human operator, autonomously by onboard computers [4] or piloted by an autonomous robot.[5]

EARTH MOVERS VEHICLE DESIGN | EXCAVATOR DESIGN

7 0 Beginner
EARTH MOVERS VEHICLE DESIGN

Does NX 7.5/8 has any toolbox (e.g to gears and pinion) like in solidworks?

7 0 Beginner
go to start in windows

DRONE ASSEMBLY DESIGN in SIEMENS NX

7 0 Beginner
Drone assembly design using Siemens NX, An unmanned aerial vehicle (UAV) (or uncrewed aerial vehicle,[2] commonly known as a drone) is an aircraft without a human pilot on board. UAVs are a component of an unmanned aircraft system (UAS); which include a UAV, a ground-based controller, and a system of communications between the two.[3] The flight of UAVs may operate with various degrees of autonomy: either under remote control by a human operator or autonomously by onboard computers[4] referred to as an autopilot.

water bottle in NX

6 3 Beginner
https://www.youtube.com/watch?v=3T122CvvFOc&t=6s

can we make single part file in which we can show all assembly parts in NX7.5?

6 4 Beginner
Hi Amol, You can do what you describe.

Self lock model

6 0 Beginner
two rings locked each other, created use NX software.

EARTH MOVERS VEHICLE DESIGN

6 0 Beginner
https://www.youtube.com/playlist?list=PLsTi7aWegx-Aj1yoQz-qFYag1v85y96vv

How to use Emboss Command in NX

5 0 Beginner
Hi Amit, Emboss is mainly used on surfaces, you can use an intersecting solid as Michael shows, you can also use a curve or sketch profile.

how we are making flat pattern in ug nx 7.5 from solid model

5 0 Beginner
analyze formability one step