Tutorials

Параметризация модели через переменные в "Компас-3D"

13 0 Intermediate
Tutorial relevant for users "Kompas-3D". I don't know if they "Kompas-3D" is used in other countries, but I know "Kompas-3D" most popular in Russia, so further explanation will be in Russian. If you need English version, please comment tutorial, and I make translate. В данной заметке рассмотрено построение параметрической модели на примере корпуса микросхем типа QFP, модель строится в САПР «Компас-3D». Представленный ниже способ - лишь один из многих возможных. И я искренне надеюсь, что кому-то он поможет лучше разобраться 3D моделированием, а кто-то увидит, как оптимизировать процесс. Несмотря на то, что построение модели выполнялось в «Компас-3D», подобные механизмы могут присутствовать и в иных системах, так что возможно пригодится пользователям другого ПО. Описанный ниже способ предполагает наличие определенного навыка работы с 3D моделями, и не содержит подробного описания последовательностей нажатия клавиш, скорее описана методика построения и взаимосвязь объектов.

IronCAD - Top 10 Tips

3 5 Expert
Ten top tips for IronCAD

IronCAD - Using the Co-ordinate system to create a section

2 0 Intermediate
Use the Co-Ordinate systems to create a section plane. This is a handy alternative the section tool, as it does not cut the solid model.

How to create a perforated sheet metal

1 1 Intermediate
could be that you want to use rectangular patern. by creating one hole and copying it over the surface of the sheet. i actually never use sheet metal parts but here it goes.

IRONCAD Training 01-04 | Drag & Drop Modeling

1 0 Beginner
Four videos that describes the Drag & Drop Modeling basics in IRONCAD.

IronCAD - Linked Cross Sections

0 0 Intermediate
Create independent parts all driven by the one linked cross section

IronCAD - Multifeature part from one Cross Section

0 0 Intermediate
Create a pipe section with flanges at each end, using one circle to drive the bore diameter with flange OD offset from this.

Tutorial: How to create a helix along a 3D curve

0 0 Beginner
Look the video. Important moments: - The orientation of cross section - Twist profile angle must be more then 360 Angel: 360*15 = 5400, Where 15 - number of coils Result file: http://grabcad.com/library/tutorial-how-to-create-a-helix-along-a-3d-curve-1