Tutorials

Tutorial: how to model revolving surfaces without degenerated point

12 2 Intermediate
This tutorial shows how to reconstruct a portion of a revolving surface, in order to remove the degenerated point

Onshape Tutorial Exersice

11 0 Intermediate
Sometimes you will not have Solidworks or a similar program installed on your computer. And you may have to make a model immediately. In such situations, Onshape is great. The link to the modeling file from the sample technical drawing is given below. https://cad.onshape.com/documents/51b10db64d8c10d69e04f4da/w/b4cd4b090cea13100d679675/e/741f8ec43a660ff55252cd29

Filling basic 6-sided holes in Rhino

8 1 Beginner
This tutorial shows how to fill a 6-sided hole surrounded by simple planar surface transitions in Rhino.

Make a Ring With Text in Rhino

7 1 Expert
Make a ring with a text

Video Tutorials from Rhino 3D Tutorials

6 0 Beginner
A series of little tutorials made available on my Youtube channel. For more detailed Rhino 3D tutorials here's the link https://rhino-3d-classes-from-beginner-to-advanced-lev.teachable.com/

GIF : Guide to How to make Simple Single Collet ( Emerald Ring )

5 0 Intermediate
THE SERIES OF ANIMATED gif WILL GUIDE IN MAKING SIMPLET GRACEFUL RING.

The Length And Width Of A Ring .

4 0 Expert
How to measure the length and width of a ring . https://www.youtube.com/watch?v=0zKmm4ZYi10

Introduction to Pave setting, and its basic knowledge.

4 0 Expert
What a Pave Setting Is The pavé setting, pronounced “pa-vay,” comes from the French word “to pave,” as in paved with diamonds. By closely setting small diamonds together with minimal visibility of the tiny metal beads or prongs holding the stones in place, the effect is one of continuous sparkle.

volleyball in Onshape

4 0 Intermediate
I wanted to get to know Onshape better and had a look at the split, transform and pattern command. I repeated this in SolidWorks and it is the same workflow.

How to model the StMary30st in Rhinoceros3D and show design intent.

4 1 Beginner
Here my explanation on how to do

starlord Tutorial - image Pixel [ sampler ] with Rhino + Grasshopper

4 0 Intermediate
éste es un Tutorial para convertir una imagen en geometrías tipo Pixel this is a Tutorial to convert an image into Pixel geometries Regards! subscribe! MATGICAL@blogspot.com f DigitalMagical magicaldigital Ig

How do i add thickness to a polyline in Rhinoceros 3D

3 2 Intermediate
hi https://grabcad.com/mark.goody-2, following picture can guide you to add thickness to any curves by adding few simple steps while modelling.

Onshape for Absolute Beginners

3 0 Beginner
https://youtu.be/2utLjjkXpIg

Filling 6-sided holes in Rhino

3 0 Intermediate
This tutorial shows how to fill a 6-sided hole surrounded by complex surface transitions in Rhino.