Static Simulation in Fusion 360! Bicycle Crank Arm Tutorial

5 0 Beginner
0:25 Simulation Start 0:56 Simplify 1:31 Materials 2:02 Constraints 2:58 DOF View 3:23 Loads 4:52 Solve In this tutorial, we will create a static simulation for our bicycle crank arm in Autodesk Fusion 360. We will simplify our assembly, to remove the fittings, then add a material, constraints and a load to the end of the arm. When we solve our assembly, we will end up with the amount of deformation. We will then run the simulation again once we core out the inside of our crank arm to see the difference in the analysis.

Static Stress Simulation: I-Beam Bending in Fusion 360! Tutorial

3 0 Beginner
How to do a static stress simulation on an I-beam in Fusion.

Fusion 360 Thermal Simulation Tutorial- Loads and Constraints Coffee Mug Part 2

2 0 Beginner
#Coffee #ThermalConduction #ThermalSimulation Music is from Youtube free library. -This is a thermal load simulation.

Autodesk Fusion 360 Tutorial - How to Draw the Assembly and Its Components on the Same Sheet

0 0 Intermediate
We can draw the assembly and its components on the same drawing sheet. It is able to be applied by unchecking some component of assembly on drawing browser. We apply the balloons and the parts list table for drawing the assembly. We apply center mark, centerline, section view, and dimension for drawing the components.

Autodesk Fusion 360 Tutorial - How to Set the Orthographic Projection

0 0 Intermediate
This tutorial is about how to set the orthographic projection on Autodesk Fusion 360. This feature is updated on October 28, 2018.