Simple 2.5D wing design using SpaceClaim for CFD CFX (attained error during meshing stage please help)

28 Oct, 2020 11:54 AM

Hi All,

Recently, I have gained a job to work in the university that I have studied, previously we used design modeler but since it is going to maintenance mode I wanted to encourage the new students to start using SpaceClaim to work with their coursework, I am currently working on making videos for the students to use however I have run through a problem during the meshing stage (probably a simple error), I have further attached the photo of the problem below, if you require further information such as my setup please let me know and I will do my best to provide you more details, thank you for your help.

ZaK

Oct 28, 2020

Can you show the picture without meshing?

Saif Majid

Oct 28, 2020

ZaK Can you show the picture without meshing?

Hi onsuzasla, I really appreciate your response not sure which particular view you'd like but I will screen shot the the same view closer without the mesh I'll post a trimetric and front view for you, thank you

ZaK

Oct 29, 2020

Do fine meshing, especially where is that small hole located.

Mark Mark

Nov 6, 2020

Saif Majid Hi onsuzasla, I really appreciate your response not sure which particular view you'd like but I will screen shot the the same view closer...

ANSYS4ALL

Created by Oleksandr Babenko on 25 April, 2018

211

4449

Simple 2.5D wing design using SpaceClaim for CFD CFX (attained error during meshing stage please help)