Hello, I am trying to mirror an extruded cut onto a revolved surface. The process failed and it gives me an error that "The projection of the sketch on the surface failed" as shown in the picture.

Accepted answer

try checking geometry pattern

1 Other answer

if this doesn't open do one thing
(i tried mirroring it didn't happen also tried couple of ways more to do the trick then also no luck).
just show the cut sketch and go to cut extrude and select the sketch, now select the other(where you want the cut) surface/face and reverse the direction
that will do the trick.
if you didn't understand i can upload the pics.