Tutorial how to make engine part 10


  1. Step 1:

    open a sketch on right plane and draw a axis for new plane

  2. Step 2:

    create a plane that have to be 35 degree between new plane and right plane. then open a sketch and draw 4 circles

  3. Step 3:

    draw two circles like shown

  4. Step 4:

    use mirror command two times

  5. Step 5:

    finally make your sketch like this

  6. Step 6:

    use extrude commad

  7. Step 7:

    open a sketc under the body and draw two circles. smaller circles radius is 50mm. other one have to be bigger then body. then use cut extrude command and enter volues

  8. Step 8:

    open a sketch on cutted surface and draw circles like this

  9. Step 9:

    make your sketch like this

  10. Step 10:

    use extrude command

  11. Step 11:

    use linear pattern command. you must to decide that how many cylinder you want. I prefered to make 12 cylinder.

  12. Step 12:

    now we will cut the surplus portions. please check the photo and try to draw a sketch on the body like this. you should use linear pattern command

  13. Step 13:

    use the command and cut the body 70mm. That's all for now. please follow the tutorial step by step. if you have a problem with the tutorials please let me know