Tutorial - Modeling guide bracket in SolidWorks?
Here is the tutorial.
-
Step 1:
Top plane>>sketch.
-
Step 2:
Draw this profile.
-
Step 3:
Extrude it by 10mm.
-
Step 4:
Top face>>sketch.
-
Step 5:
Draw a circle of 40mm dia.
-
Step 6:
Extrude it by 35mm.
-
Step 7:
Top face>>sketch.
-
Step 8:
Draw this entity using rectangle.
-
Step 9:
Extrude it by 28mm.
-
Step 10:
Fillet.
-
Step 11:
Fillet the edges of the previous extrude by 10mm.
-
Step 12:
Top face>>sketch.
-
Step 13:
Draw two circles equal to the edges and concentric to them also.
-
Step 14:
Extrude it in both direction by 2mm and 30mm.
-
Step 15:
Top face>>sketch.
-
Step 16:
Draw three circles concentric.
-
Step 17:
Extrude cut by through all.
-
Step 18:
Side Face>>Sketch.
-
Step 19:
Draw a circle of 10mm dia.
-
Step 20:
Extrude cut by through all.
-
Step 21:
Top face>>Sketch.
-
Step 22:
Draw this profile.
-
Step 23:
Extrude it up to the bottom surface.
-
Step 24:
Repeat the same step for other side too.
-
Step 25:
Right Plane>>Sketch.
-
Step 26:
Draw two circles of 10mm dia.
-
Step 27:
Extrude cut >> through all in both directions.
-
Step 28:
And we have the part.
