Tutorials

How to assemble separate components of a 3D model in virtual reality using SimLab Composer?

5 0 Beginner
Description: In this tutorial we will teach you how assemble separate parts of a three-dimensional model using the virtual reality VR docking tool of SimLab composer. To do so, we are using a 3D model of a table, with two versions: version A, assembled model, and version B, disassembled components (which are in this tutorial the table parts).

How to Create a Press Tool Assembly in CollabCAD

1 0 Beginner
Press Tool Assembly

RE:Connect Toolkit explained

0 0 Beginner
How to use this toolkit

"Failsafe" ESPHome Fireplace Controller

0 0 Intermediate
When asked what smart switch to use to control their gas fireplace, you see a lot of replies "do you want to be one software bug away from your fireplace turning on?" Granted, modern gas fireplaces have safeties in place to prevent un-lit open valves, runaway heating, etc., but some people would still rather have a hardware switch standing between them and fire. This project aims to be the best of both worlds: by running 5v power to the low-voltage switch box holding my fireplace wall switch (in my case, this involved pulling 5-conductor thermostat wire using the existing 2-conductor wire), you can power an ESP board running ESPHome. By running the actual thermostat switch signal through both a DPST and a (ESPHome-controlled) 3v relay, we can be sure that the fireplace is only "active" if the manual switch is turned on.

assemblies

0 0 Beginner
framing assemble in rhino

How to Create a Knife in CollabCAD

0 0 Intermediate
Kitchen Knife Assembly Created in CollabCAD

Dynamic Block Creation (Visibility)

0 0 Beginner
Using the Visibility Parameter function, you can control the display and hide a certain view in Dynamic Block. Using GstarCAD software.